■ Fully Automatic Controls—Fast-acting surface-mount thermostats for
automatic temperature control. Factory-installed sensitive manual reset energy
cutoff for safety to prevent overheating.
■ Low Restriction Brass Drain Valve—Durable tamper-proof design.
■ Direct Heat Transfer with Immersed Elements—Transfers heat directly
and efficiently to the water. Screw-in style.
■ Factory-Installed Hydrojet® Total Performance System—Cold water inlet
sediment reducing device helps prevent sediment build-up in tank. Increases
first hour delivery of hot water while minimizing temperature build-up in tank.
■ Vitraglas® Lining—Bradford White tanks are lined with an exclusively
engineered enamel formula that provides superior tank protection from the
highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the
steel surface by firing at a temperature of over 1600°F (871°C).
■ Non-CFC Foam Insulation—Covers the sides and top of the tank, reducing
the amount of heat loss. This results in less energy consumption, improved
operation efficiencies, and jacket rigidity.
■ Water Connections— 3⁄4" NPT factory-installed true dielectric fittings extend
water heater life and ease installation.
■ Factory-Installed Heat Traps —Design incorporates a flexible disk that
reduces heat loss in piping and eliminates the potential for noise generation.
■ Protective Magnesium Anode Rod—Provides added protection against
corrosion for long trouble-free service.
■ Simultaneous and Non-Simultaneous Operation Available—
Simultaneous operation indicates when both elements (if equipped) are being
heated at the same time. Non-Simultaneous operation indicates when one
element is being heated at a time.
■ Voltages Available—120V, 208V, 240V, 277V, 480V.
■ Single Phase or Three Phase Operation Available—120V & 277V may
only be wired for single phase operation.
■ T&P Relief Valve—Installed.
■ Design evaluated by ETL in accordance with Part 280.707(d) of HUD
Mobile Home Construction and Safety Standards for Energy Efficiency.
|Weight||144 Pounds (lbs)|
|Width||24 Inches (In)|
|Height||47 Inches (In)|
|Country of Origin||USA|
|Length||24 Inches (In)|
|Compliance||C.E.C. Listed. Meets NAECA Requirements.|
|Composition||Copper Screw Type Immersion Element; Brass Drain Valve; Steel tank; Insulation System - Non-CFC foam; Protective Magnesium Anode Rod|
|Energy Star Rated||No|
|Finish||Vitraglas® Lining - Enamel|
|Maximum Pressure (PSI)||150|
|Number of Elements||2|
|Type||Residential Upright Electric Water Heater|